Volume 4, Issue 2, December 2018, Page: 72-77
Liquid Cooled Technique for Solid State Power Amplifiers in the Satellite Control Earth Stations
Olufunke Janet Alao, Department of Satellite Ground Control Station, Centre for Satellite Technology Development, Abuja, Nigeria
Olatunbosun Tafa Yusuf, Department of Mechanical Engineering and Manufacturing, Centre for Satellite Technology Development, Abuja, Nigeria
Sikiru Yommy Aiyeola, Department of Space System, Centre for Satellite Technology Development, Abuja, Nigeria
Mosunmola Bosede Sidiku, Department of Engineering and Space System, National Space Research & Development Agency, Abuja, Nigeria
Received: Oct. 1, 2018;       Accepted: Oct. 25, 2018;       Published: Nov. 29, 2018
DOI: 10.11648/j.ijecec.20180402.11      View  1030      Downloads  145
Solid State Power Amplifier (SSPAs) excessive thermal dissipation with high failure rate are becoming challenging tasks in the operation of satellite earth stations. Traditionally, forced-air cooled method has been the most well-known method adopted in removing excessive heat from high power SSPAs, but has not really prove so effective to bring down the heat to barest minimum. In this paper, we present the use of a liquid-cooled by developing a robust control system and heat exchanger module using temperature sensor, micro controller and water as coolant. Our design aims to optimize and increase the efficiency of the power amplifiers output and prevent failure or damage. The liquid-cooled thermal control module was built, assembled and tested within and outside the 35°C to 85°C operating temperature ranges of a typical SSPA. The result obtained shown that at the preset temperature of 35°C and below, the fan and pump were in the OFF state. At temperatures above 35°C, the fan and pump went into ON state simultaneously. In the event of fan or pump failure, (i.e. temperature above 85°C), the SSPA will automatically shuts down, the alarm will turn ON and the liquid crystal display (LCD) displayed fault. As the trend towards higher power dissipation and more concentrated heat sources continue in power amplifiers, a more effective solution is to use liquid cooled thermal control module to efficiently reduce heat dissipation in solid state power amplifier. It can be deduced from the overall results that aggressive heat dissipation removal in SSPAs is possible with liquid-cooled thermal control module.
SSPA, Heat, Coolant, Forced-Air Cooled, Liquid-Cooled
To cite this article
Olufunke Janet Alao, Olatunbosun Tafa Yusuf, Sikiru Yommy Aiyeola, Mosunmola Bosede Sidiku, Liquid Cooled Technique for Solid State Power Amplifiers in the Satellite Control Earth Stations, International Journal of Electrical Components and Energy Conversion. Vol. 4, No. 2, 2018, pp. 72-77. doi: 10.11648/j.ijecec.20180402.11
Copyright © 2018 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Faisel EM M Tubbal, Akram Alkaseh and Asem Elarabi, “Telemetry, Tracking and Command Subsystem for LibyaSat-1, University of Wollongong Research Online,” 2015.
Zhang Yinlong, “Satellite control center and china satellite telemetry, tracking and control network,” University of Wollongong Research Online Australia, 2018.
Robert A. Nelson, “Earth station high power amplifiers KPA TWTA OR SSPA, Applied technology institute viasatellite,” 1998.
Akhilesh Jain, P. R, Hannurkar, D. K. Sharma, A. K., Gupta, A. K., Tiwari, M. Lad, R. Kumar, P. D, Gupta and S. K, Pathak, “Design and characterization of 50 kW solid-state RF amplifier, International journal of microwave and wireless technology, 2012.
http://www.microwavejournal.com/articles/1181-a-compact-efficient-25-w-ku-band-power-amplifier/. Retrieved 2013.
Adriano da Silva Dias, Diogo Brum Cândido, Anand Placido Almeida and Joable Andrade Alv, “Cooling methods design for power electronics converters. Juiz De Fora Brazil IEEE Xplore,” 2018.
https://heatsinks.files.wordpress.com/2011/02/cooling-high-power-led.pdf/. Retrieved 2018.
https://www.mouser.com/datasheet/2/412/TQP3M9019894309.pdf/. Retrieved 2018.
http://www.lytron.com/Cold-Plates/. Retrieved 2018.
Jingyan Liu and Shunjing Guo, “Resistance furnace temperature control system based on PIC single chip, 8th International Symposium on Computational Intelligence and Design (ISCID, IEEE Xplore, Hangzhou, China,” 2016.
S. R Sharma, P. B. Dahikar, J. M. Pate and K. N. Mahavidyalaya, “Embedded design of temperature controller using PIC 16F876A for industries and laboratories, International Journal of Innovative Research in Computer and Communication Engineering (IJIRCCE),” 2014.
Browse journals by subject